The CPM-700 With The RF Probe And Low Leakage Headphones

DETECTION FUNCTION ONE RF SWEEPING
RF sweeping is done quickly, easily and silently with the CPM-700 by attaching the RF probe. The RF probe provides rapid and silent spectrum coverage from 200Hz to over 3GHz with no holes or gaps. Due to superior sensitivity, the CPM-700 can locate even a low powered bug down to 1 microwatt.The sweep range and sensitivity in R.F. mode will also detect video transmitters. Also due to it's high sensitivity, The CPM-700 will detect snuggled bugs as well as burst transmission bugs while transmitting.

DETECTION FUNCTION TWO PHONE LINE R.F. SWEEP
Extremely easy to use to check phones and phone lines in the R.F. sweep mode function much like an induction coil with the R.F. probe.

DETECTION FUNCTION THREE TELEPHONE LINE TESTING
With the Modular Telephone Line Testing Jack and the Line Probe, all wire pairs can be checked on a telephone system to determine if it's clear of eavesdropping. The unit will work on both single line and multi-line telephones. NOTE: Even a single line telephone system has four wires of which only two are actually used. With the Modular Telephone Line Testing Jack, you can check ALL wire pairs for possiable audio bugging on BOTH single and mult-line phones.

DETECTION FUNCTION FOUR HOOKSWITCH BYPASS TESTING
With the included adapters, you can conduct a hookswitch bypass test (and modification to the telephone itself that turns the headset microphone into a bug) and other telephone equipment testing.

DETECTION FUNCTION FIVE
ELECTRICAL OUTLET CARRIER CURRENT TESTING
With the VLF probe you can quickly, easily and silently test all electrical outlet for carrier current eavesdropping.

DETECTION FUNCTION SIX ELECTRONIC DEVISES
Using a combination of the line probe and and the included plug conversion, you can test anything that plugs into an electrical outlet for eavesdropping devises.

DETECTION FUNCTION SEVEN IR (INFRARED) TESTING
IR is an invisible light source and a common way in which audio can be carried from any premises. The IR probe can be used inside the premises to detect IR beams with audio.

DETECTION FUNCTION EIGHT VIDEO CAMERA DETECTION
Sweeping for the presence of video cameras is becoming increasingly important. The magnetic leakage probe will detect and locate hidden video cameras.

DETECTION FUNCTION NINE RECORDER DETECTION
Sweeping for the presence of hidden tape recorders is also becoming increasingly important. The magnetic leakage probe will detect and locate hidden tape recorders.

DETECTION FUNCTION TEN UNKNOWN WIRE TESTING
The source of unknown wires found in a physical inspection are sometimes problemistic on a countermeasures sweep but not with the CPM-700. Using the auxiliary input plug and patch cords, you can easily, quickly and silently check any wire you find for audio.

DETECTION FUNCTION ELEVEN OUTSIDE LASER BEAM DETECTION
Using the IR Probe, it's quite easy to go around the outside of the building to detect any lasers that may be pointed at the windows of the building.

DETECTION FUNCTION TWELVE ACOUSTIC LEAKAGE DETECTION
It is quite common place for eavesdropping to occur without the aid of any electronic devises at all and it often due to the acoustic characteristics of the building. The Acoustic Leakage Probe can be used to check walls, vents and pipes that could create possible acoustic leakage problems. Once detected, additional countermeasures procedures can be recommended in the form of Acoustic noise generators injected in a strategic manner.

DETECTION FUNCTION THIRTEEN VEHICLE TRACKING DEVICES
The CPM-700 will detect and locate R.F. tracking transmitters which are used to follow vehicles. The typical "bumper Beeper" will employ a minimum output of 100 milliwatts to more than 5 watts and usually have a pulsed output.

DETECTION FUNCTION FOURTEEN
COMPUTER TEMPEST COMPARISON
The CPM-700 can be used to compare emissions from Tempest Approved Equipment.

DETECTION FUNCTION FIFTEEN AUTOMATIC MONITOR MODE
The CPM-700 can be placed on automatic monitor mode once a sweep has been conducted and detect and alarm you to any changes while one is away.

ADDED SECURITY/DETECTION FUNCTION SIXTEEM
UV MARKING PEN AND UV INSPECTION
With the professional UV marking pen and UV detection light, you can mark the position of screw heads on electric outlets, light switches, telephones, lamps and other objects you take apart for inspection. Once done, the UV light will tell you in an instant if the object has been opened again by re-checking the postion of the crew heads with the UV light source.

RETURN TO CPM-700 FRONT PAGE


CLICK HERE TO SEE THE CPM700 IN ACTION
REVIEW FRONT PANEL SETTINGS AND OPTIONS
READ ALL ABOUT THE FIFTEEN MAJOR DETECTION FUNCTIONS
REVIEW TEST PROBES FOR THE CPM-700
CPM-700 TECHNICAL SPECIFICATIONS
CLICK HERE TO REVIEW THE UV TSCM INSPECTION PACKAGE
CLICK HERE TO REVIEW THE CPM-700 TRAINING PACKAGE